Power Generation NDT Reference Standards
RUSH Service Available
NDT Standards for the Power Generation Industry
PH Tool™ supplies the Power Generation industry with the best NDT Reference Standards available today. We understand the nature of your business and are committed to delivering top quality standards on time. PH Tool can supply the complete standard, or we'll work with customer-furnished materials. Pictured below are a few of the popular blocks used today including: Ultrasonic Testing (UT) calibration blocks, Eddy Current Testing (ET) calibration tubes, and UT Bolting standards.
PDI ALTERNATIVE ASME Calibration Blocks
The new PDI Alternative ASME blocks meet the requirements of the Performance Demonstration Initiative (PDI) Procedure No. PDI-UT-1, Rev. C, Fig. 4 (Ferritic) and PDI-UT-2, Rev. C, Fig. 4 (Austenitic). These cover the generic procedures for the ultrasonic examination of both ferritic and austenitic pipe welds. The blocks offer users an economical alternative to fabricating multiple curved cal blocks (pipe sections) in many diameters and wall thicknesses.
The blocks are normally supplied in sets of 3 individual blocks; one in A516 Grade 70 Steel, one in Type 304/304L Stainless Steel, and one in Type 316/316L Stainless Steel. Individual blocks of any one alloy are also offered.
ASME Sec. XI Calibration Blocks
This block meets the requirements of ASME Section XI, Figure III-3230-2. Block shown is Carbon Steel base metal with a Stainless Steel weld clad. The weld clad was performed while the pipe was 360º and was bored to a specific clad thickness. The two ID notches are through the clad and into the base metal as required. This block is available in any size or alloy needed, clad or not clad. Contains four EDM notches and four side-drilled holes at 1/4T and 3/4T, axially and circumferentially oriented.
We also offer the popular ASME Section V, Article 5, Figure T-5184.108.40.206 Angle Beam Calibration Block containing four EDM notches.
Assorted ASME Ultrasonic Calibration Blocks
Photo shows a pipe section, nozzle, and bolting standard. All contain EDM notches and/or drilled holes. Can be machined from customer or PH Tool-supplied material. Uncommon sizes and shapes can be machined too. Pipe section at left was turned and bored from solid round bar due to the special size required.
ASME Sec. V Article 8 Eddy Current Calibration Tube Standards
Available in various alloys and sizes. This standard contains drilled FBHs, through-wall holes, and OD/ID grooves. Other standards with EDM notches, ID pits, wearscars, wall loss, ID FBHs, controlled dents, and milled flats available. Tube Support Simulation Rings also offered.
Inventory of certified tubing is maintained at PH Tool including stainless steel, copper-nickel, admiralty brass, inconel, titanium, monel, carbon steel and others. Our network of qualified material suppliers is ready to supply materials not currently in our stock.
ASME Sec. XI Stud Calibration Standards
RPV Closure studs, Reactor Head studs, RCP studs and others can be EDM notched. Notches can be in the heater hole, in the thread, or on the shank. Notch reflective area meets the 0.059 and 0.028 square inch requirements.
EPRI Basic Calibration Blocks
Shown at left on pallet are 3 EPRI blocks per CS-4774 Fig. A-3 and 2 ASME Basic Calibration blocks (flat) per Sec. V Art. 5 Fig. T-542.2.1 in various thicknesses. We offer the COMPLETE manufacturing service including supplying the raw material, or we'll work with customer-supplied materials.
EDM Notches can be machined in various locations on studs and bolting materials.